How to solve the problem of the Pedal assist function not working but also no display error code?
There are two situations where the pedal assist function does not work:
- The pedal assist function does not work, but the throttle can work normally.
Solution:
- Firstly, check all wires for wear and looseness (you can reinsert the wires and restart the display to ensure that there are no loose wires causing poor contact).
Special inspection of the Booster sensor wire to ensure that the pins on the surface and inside the wire interface are not bent or damaged.
If the wiring is damaged, the damaged parts need to be replaced.
- If all wires do not have the above issues, you may need to replace the Booster sensor or controller.
- The throttle is not working, and pedal assistance is also not working properly.
Solution:
- Check all wires for wear and looseness (you can reinsert the wires and restart the display to ensure that there are no loose wires causing poor contact).
Special inspection of the sensor line and throttle line to ensure that the pins on the surface and inside the line interface are not bent or damaged.
If the wiring is damaged, the damaged parts need to be replaced.
- If all wires is normal, you may need to replace the controller or integrate the mainline.
For further assistance, please be sure about the cases listed above and reach the SOHAMO support team at: support@sohamo.com
Related post
18
Nov
29
Oct
17
Aug
03
Aug
20
Jul